This is pretty much rolling into the throttle to WOT. FFF Longtubes + X-pipe to turndowns just ahead of axle. No mufflers...
From: WarShrike




Just easing onto the throttle like I would for daily driving. FFF Longtubes + X-pipe to turndowns just ahead of axle. No ...
From: WarShrike




LS1 TA Magnaflow Catback MTI Lid and BBK longtubes andTuned by Doc @ EFI Alchemy...
From: DirtyBird




Idle video of the new cam, !emissions, ORY and longtubes through a magnaflow. ...
From: JPack




Final setup. Decided going with dual exhaust was a fools errand....
From: WarShrike




333 hp 344 lbft Lid, LS6 Intake, LPP Stainless Longtubes, 3 in ORY, !EGR, !AIR, DMH Electric cutout...
From: Schuby87




333 hp 344 lbft Lid, LS6 Intake, LPP Stainless Longtubes, 3 in ORY, !EGR, !AIR, DMH Electric cutout ...
From: Schuby87




Did a short run in the car outside as requested by some members. This is just a warm startup, idle (~600 rpms), rev to 2500 ...
From: WarShrike




Stock 350 LT1 with Pacesetter longtubes, ORY, 3" cutout open, with Hooker Aerochamber muffler ...
From: Hollo









Stock 350 LT1 with Pacesetter longtubes, ORY, 3" cutout closed, with Hooker Aerochamber muffler.. Just some small revs...
From: Hollo




As part of a test, I had dyno tested 3 configurations: 1. Bone stock, 2. Stock, but with FFF LTs and home made 3" catbac...
From: GSJon



