kidcamaro98's Vehicle Feed
Basic Specifications
Vehicle Color: Arctic whiteEngine Type: 8 Cylinder
Transmission: Manual
Est. Horsepower: 412 HP
Est. Curb Weight: 3,400 lbs.
Mileage: 43,000 miles
Sites in the FQuick Network
Get your forum exposure. Click here and join for FREE!kidcamaro98's 2001 Chevrolet Camaro SS
my 2001 Camaro M6 SLP SS
About this Current Vehicle:
Heres a quick video of my LS6 Camaro SS vs a local GT30R Honda prelude that put down 333whp....from a 40 roll to 150
http://youtube.com/watch?v=6gc_1xEl3z4
Same race...40-150. Prelude has a 2 car head start...
http://youtube.com/watch?v=DIIaFoGtjcs
My SS vs a full bolt on 2000 camaro Z28 from a 35 roll...the Z28 is the camera car...35-155+
http://youtube.com/watch?v=UCZKzcWgi7w
Vehicle Journal:
Apr 12
MS3 cam installed
Few weeks ago had a MS3 cam installed with supported mods (stock heads) and dyno tuned...heres a idle clip.
http://www.youtube.com/watch?v=wtLhC7NwBec
Dec 09
picked up a cam
Bought a MS3 cam with 112 LSA, chromoly 7.425 pushrods, ported LS6 oil pump and Livernois dual valve spring kit.
Nov 16
Dyno Day
went to a local dyno day on the 2nd of November. It was on a dyno pack, which reads 10% lower then a dyno jet and the same as a mustang dyno. Car made 351rwhp and 355rwtq without a tune! Its still on the stock LS1 tune, with a bolt on 01 LS6 long block...atleast 15rwhp more is in store after a dyno tune! but A cam will be going in before that 
Factory Options:
fully loaded, t-tops
Exterior Modifications:
Black Ruff Racing 280's.
Good year eagle F1's....315's.
Interior Modifications:
N/A
Performance:
01 LS6
Texas-speed MS3 Cam
Ported LS6 oil pump
Patriot performance dual gold valve springs/titanium retainers/locks
LS2 timing chain
TR-55 plugs
Thunder Racing 7.425 Chromoly push rods
SLP lid,
K&N air filter,
Hurt short throw shifter,
SLP Center Mount exhaust with SLP rear valence,
Ported throttle body, Hooker long tube headers,
Pace setter Off road Y pipe
Suspension/Chassis:
BMR Lower Control arms,
BMR adjustable torque arm,
Eibach Pro kit lowering springs,
KYB AGX adjustable shocks.
BMR Lower control arm relocation brackets
SSR Strut bar
Drivetrain:
stage 2 Ram clutch
Electronics:
N/A
To-Do List:
N/A
Copyright © 2009 FQuick.com. Terms of Use & Privacy Policy
8 Comments on kidcamaro98's Camaro SS
Hello
Got ya ranked. Car looks good! See ya around FT
nice SS man...camaro's sure look good in white
Nice SS. This cars about as cool as your 3.8. Love both cars.
Thanks for the comments! Yours looks good too. I wish mine had that CME though!
Also, my headers and Y are Kooks, not Pacesetters.
Hey man, thanks for the comments!
My torque arm mount is the one from Spohn that is actually not for long tubes. However it does not rub or bang at all. I have solid motor mounts so my Y-pipe does not move at all, which is how I got away with this
nice car...gotta love white camaros...so u still have the 98 too? lucky, lucky man
Cam swap is pretty straight forward. there is a good doc on how to do it on LS1howto.com.
Nice car man! Used to have a white one myself.