NJSPEEDER's 1976 Chevrolet Camaro

Factory Options:

Have been removed. I have a design for a compact front sindshield defogger layed out. i have to grab a few more components and then wait until the dash is reasembled to see if my theories and design are solid. If it works you can all expect to see a full tech article on the design and fitment to be found at www.NJFBOA.org

Exterior Modifications:

1979 Front Clip
Black Headlight and Driving light Buckets from a 1980 Camaro Z28
N90 Wheels from 1980 Camaro Z28
!vinyl roof

Interior Modifications:

Everything is getting cleaned up. I am at the point of making final decisions about what seats and such to install. I am also thinking i may as well just go ahead and plan to have the roll bar installed since I will get kicked out first pass without it.

Performance:

GMPP Crate Engine + Small Nitrous Shot
Some weight reduction as well.

Suspension/Chassis:

Lakewood 90/10 fronts and 50/50 rears, Soon to have Caltracs and Calvert Racing composite monoleaf springs.

Drivetrain:

My 200-4R core is cleaned up and ready to be built by the folks at www.dynotechperformance.com It will be their best rebuild and hopefully enough to last a very long time.
I am also pulling the rear out this week to sell. Hopefuly i can save up a few bucks and get a 12bolt or similar w/4.10 gears in there before the season starts in march.

Electronics:

The only things that were electronic in the car were the speakers and head unit, they have been removed in the name of weight reduction. :D

To-Do List:

N/A