JimW's 1967 Chevrolet Camaro

Project Tetanus

About this Current Vehicle:

Allways wanted a 1st gen, This was a Ebay find.. might look like crap to most but it was unmolested (meaning it was all there and had not been hacked up over the years). the 327runs very well and the powerglide still shifts.

Did I say its rusty .. but the trunk floor, subframe and rear frame rails are near perfect.
UPDATE after tear down I found that both rear frame rails are kinked bad enuff that they need to be replaced .. after much debate .. I'm replacing them with Comp. Engineering pre formed box rails.

2 weeks after I bought the car, I ordered allmost every peice of sheet metal

roof skin and brace kit
both quarters with drop offs
shock tower panels
outer wheel house
whole front clip with cowl hood
deck lid, deck panel and speaker shelf panel
tail panel with brace

I hope to have all the sheetmetal work done this winter .. if work at the shop ever slows down.

This project will be based on Pro-touring.